Setting up a wired or wireless home network has many benefits than just having Internet access for multiple computers in your home. Today, it’s almost a necessity to be able to plug in or connect via wireless to your network from any room in your house.

With many people who set up a home network, they end up under utilizing their home network and only use it for Internet access, attached to one computer.

Today, that kind of network setup is old school. Adding a router to your network, turns a home network into a LAN (Local Area Network) opening up many possibilities of what you can do on your network. Even if you have just have one Computer, many devices exist (other than computers) that are network capable, allowing interaction with other.

So what can you do with all this technology? Here are ten uses for what you can do on your home network. More »

Vista DVD include all the vista version and include more feature that cause it need a high speed computer with at least CPU=2.0Ghz , Ram=512,HDD=30Gb But we can reduce some feature to make it smaller,faster and can support computer only 800 Mhz, Ram=256, HDD=5Gb…you will enjoy it by following remove this feature below:

# accessories #
accessibility
mobility center
speech support
welcome center

# drivers #
printers, modems & scanners
graphics ,sound and ethernet drivers are still included.

# games #
all games removed

# hardware support #
fax support
internet small computer system interface (iscsi)
smartcards More »

The first thing that you will have to make a decision on while planning out your home network is will your network will be wired or wireless. The notion in each case will stay put the same where in all your computers will join up to a central router, which will talk the connections to your ISP from side to side a cable or a DSL modem.

It is a frequent fact the wireless home network provides much more expediency than wired networks. They do not necessitate cabling and permit users to move from one room to another with freedom. But wired networks are more secure and dependable and if you can use again the existing phone lines or the electrical wiring, then the cost of installing new cables are reduced radically. More »

If you use a Point-to-Point Protocol connection over Ethernet (PPPoE), you may notice a delay in using the PPPoE connection after startup. By default, there is a 120 second delay but you can stop this behavior by manually configuring an IP address for the network adapter card. If you do not use a PPPoE connection, you can skip this section.

1. Select Start/Connect to/Show All Connections.

2. Open the TCP/IP properties for your LAN network interface card.

3. Manually set the IP address on the TCP/IP properties to an appropriate IP address and subnet mask for your network.