Tag: trouble

5 Tips For Computer Troubleshooting

February 02, 2009 by Jason

1. Your computer isn’t turning on? “Oh, no!” You think, “I’d better get a new one!” STOP right there. Before you get too frustrated, be sure you have checked that the power cord is actually plugged into your wall socket properly. You may think it sounds silly, but believe me, it’s more common than you think even for the computer savvy. If your computer is connected through a power board, you should try plugging it directly into the wall (note for the safety conscious: by plugging the power cable directly into the wall, you lessen the chance of power failure and damage to your machine). Another reason that your PC may not start is if you have made any repairs or modification to your machine. You may have unwittingly pulled out a connect plug; check all connections.

2. If your computer is starting but is spitting error messages at you, then you might need to take out any memory modules such as RAM and then reset them by plugging them back into different RAM slots.If you get an error such as ‘Unexpected Interrupt in Protected Mode,’ then there is a problem with the settings you have entered in BIOS. To fix it go into BIOS and set it to default settings. If the problem still won’t go away, then you must remove the CMOS chip on your motherboard then put it back in to clean BIOS completely. Read More»

Install Windows XP On Windows Vista Without Formatting Hard Drive

December 08, 2008 by Jason

In this post we are going to share with you the experience we had while trying to Install Windows XP on new laptop which has Windows Vista and how we achieved it virtually.

I bought a HP Pavallion notebook which had Windows Vista, and first thing I wanted was to make it dual boot with Windows Vista and Windows XP. I studied a lot of articles on Internet for installing Windows XP on new laptop. So I did a spilt-streaming of SATA drivers and Windows XP onto a same CD using nLite tool. The CD was able to start the setup, but as soon as the system restarted between, all was gone, it neither booted again with XP setup nor it had Vista on boot-loader anymore.

Finally I was back to face this reality that these new pieces of hardware are not happy to run Windows XP because of driver issues and other compatibility problems. I was disappointed with this for a week or so, after which I realized that we can do a Virtual Install with a tool from Microsoft. This tool is called Virtual PC, so I will tell you how I Installed Windows XP on Windows Vista without any trouble. Read More»